Batgirl
05-23-2010, 08:51 PM
Bought one of the JC Whitney top cases that Sear's was selling back in March. Picked up a used SV pillion seat and then let them both sit in the hallway for 2 months. :myfault: Finally had the free time and the motivation to get the project done. So, off David and I went to the garage. Here are a few pics of the progress and the final outcome. Now, commuting to work and weekend trips will be a little more comfortable. Thanks go to BlueLghtning for suggesting the use of the extra seat for mounting the top case and i-man for helping get the whole project done. Although, the scream while I was drilling the seat you were holding was not funny.
Picture of seat after removing padding and re-covering. In this picture, you can see the 4 holes that were drilled through the cover and seat for the mounting brackets.
http://i290.photobucket.com/albums/ll251/Batgirl7_photos/Bike%20stuff/S7302211.jpg
Bottom side of the seat showing the 4 holes drilled for mounting the brackets.
http://i290.photobucket.com/albums/ll251/Batgirl7_photos/Bike%20stuff/S7302212.jpg
After inserting the bolts through the mounting plate, the seat and the brackets, I installed it on the bike to check fit and clearance. Making sure that the bolts don't hit anything under the seat.
http://i290.photobucket.com/albums/ll251/Batgirl7_photos/Bike%20stuff/S7302214.jpg
http://i290.photobucket.com/albums/ll251/Batgirl7_photos/Bike%20stuff/S7302215.jpg
The finished project.
http://i290.photobucket.com/albums/ll251/Batgirl7_photos/Bike%20stuff/S7302218.jpg
http://i290.photobucket.com/albums/ll251/Batgirl7_photos/Bike%20stuff/S7302219.jpg
Picture of seat after removing padding and re-covering. In this picture, you can see the 4 holes that were drilled through the cover and seat for the mounting brackets.
http://i290.photobucket.com/albums/ll251/Batgirl7_photos/Bike%20stuff/S7302211.jpg
Bottom side of the seat showing the 4 holes drilled for mounting the brackets.
http://i290.photobucket.com/albums/ll251/Batgirl7_photos/Bike%20stuff/S7302212.jpg
After inserting the bolts through the mounting plate, the seat and the brackets, I installed it on the bike to check fit and clearance. Making sure that the bolts don't hit anything under the seat.
http://i290.photobucket.com/albums/ll251/Batgirl7_photos/Bike%20stuff/S7302214.jpg
http://i290.photobucket.com/albums/ll251/Batgirl7_photos/Bike%20stuff/S7302215.jpg
The finished project.
http://i290.photobucket.com/albums/ll251/Batgirl7_photos/Bike%20stuff/S7302218.jpg
http://i290.photobucket.com/albums/ll251/Batgirl7_photos/Bike%20stuff/S7302219.jpg