WANTED: OEM Plug

[Mr1080]

Installing flush mounts, but my dog go to my stock turn signals and the OEM Plug attached to them before I could. Anyone have the plug or know where I can get them?

[NiceGuysFinishLast]

Why not just cut the connector off and use any connector you can buy at radio shack for $.10?

[Mr1080]

Why not just cut the connector off and use any connector you can buy at radio shack for $.10?

That's why I post on here, for people like you. I am not the electrical type and figured it would be easy to find the dump plug and go from there (cut, splice, done); not so to smart seeing as two weeks later and I don't have the plug. I will take your advice and check out radio shack and see what I can find. Thanks!!

[Mr1080]

is there an actual name for the "male and female" of these plugs?

[NiceGuysFinishLast]

I don't know. But I imagine if you cut off one of the stock ones and took it to radio shack, they could get you a connector to replace it with. For turn signals, you really don't have to worry about much, there's almost no amperage running through there, it's tiny gauge wire, any connector you use should work fine. Hell, you could just splice 'em together if you wanted to.

[Georgiacbr]

I don't know. But I imagine if you cut off one of the stock ones and took it to radio shack, they could get you a connector to replace it with. For turn signals, you really don't have to worry about much, there's almost no amperage running through there, it's tiny gauge wire, any connector you use should work fine. Hell, you could just splice 'em together if you wanted to.

Yea Niceguysfinishlast is correct simple install here. Now messing with the Ceramic Diodes are a pain in the ass. I had to mess with mine a wile back because it wasn't making a good connection and it was ripped out. Thank god I took Electronic classes In College and High School that was taken care of the right way after Dave from Marmo figured that out and it puzzled me.

[MX Tuner]

Radio Shack won't have the correct connector. You could cut and crimp some male and female connectors. That'll be your path of least resistance.

[Mr1080]

Thanks for all your help guys. I did take the advice of Niceguy (and Overtwo when I went to the shop to drop off my tank to be painted) and spliced them together, took my 5 minutes to go both sides and they look great. I'll post up pics in my forum under the mods.

Again, Thanks

[NiceGuysFinishLast]

Glad you got it sorted!